Home > DJ POWER AMPLIFIERS > QSC AMPLIFIERS > QSC RMX-5050 Professional Power Amplifier


QSC RMX-5050 Professional Power Amplifier - click to enlarge

QSC RMX-5050 Professional Power Amplifier

RMX5050
2 Channel, 1100 watts/ch at 8 ohm, 1800 watts/ch at 4 ohms, 2500 watts/ch at 4 ohms (bridged)

QSC’s RMX 5050 power amplifier represents the state-of-the-art in professional quality performance at an affordable price. Perfectly suited for a wide range of sound reinforcement applications including professional touring, performing musicians, and mobile entertainers, the RMX 5050 is optimized to deliver high levels of sustained power, extraordinary audio performance and road-proven reliability.

Like its smaller sibling (the RMX 4050HD), the RMX 5050 features a three-tier, Class H design. The RMX 5050 is extremely efficient at real world power levels. Less AC current is wasted and more goes into producing useful audio power. The RMX 5050 uses the best available component upgrades to increase peak power by 25% over the RMX 4050HD.

Like all RMX amps, the RMX 5050 features balanced 1/4" TRS, XLR and barrier strip inputs, binding posts and Neutrik Speakon™ outputs, front-mounted gain controls, plus signal and clip LED indicators to monitor performance.

Features:
  • Provides extremely high power and represents tremendous value
  • The RMX 5050 provides advanced thermal performance
  • Higher continuous power in 2-ohms stereo or 4-ohms bridged applications
  • Dual mono, high current power supply for increased reliability and performance
  • 3RU chassis only 16" deep
  • Professional quality performance—incorporates road-proven QSC designs
  • High-current toroidal transformers for greater two-ohm power and low noise
  • Independent user-defeatable clip limiters reduce distortion
  • Selectable low-frequency filters (30 Hz or 50 Hz)
  • Balanced 1/4" (6.3 mm) TRS, XLR, and barrier strip inputs for maximum flexibility
  • Binding post and Neutrik Speakon™ outputs
  • Front mounted gain controls for easy access
  • Signal and Clip LED indicators to monitor performance
  • 3-year warranty




    BRIDGE-MONO MODE
    8 ohms FTC 20 Hz-20 kHz 0.1% THD
    3200 Watts
    8 ohms EIA 1 kHz 0.1% THD
    3600 Watts
    4 ohms EIA 1 kHz 1% THD
    5000 Watts
    Distortion (SMPTE-IM) Less than 0.02%
    Distortion (Typical)
    20 Hz-20 kHz: 10 dB below rated power
    1 kHz and below: full rated power

    Less than 0.02%
    Less than 0.02%
    Frequency Response

    20 Hz to 20 kHz, 8 ohms, LF filter bypassed, +0/-1 dB
    5 Hz to 50 kHz, 8 ohms, LF filter bypassed, +0/-3 dB
    Damping Factor Greater than 250 @ 8 ohm
    Noise (unweighted) 100 dB below rated output (20 Hz to 20 kHz, 8 ohm load)
    Input Sensitivity 1.42 Vrms for 1050 watts into 8 ohms
    Controls Front:
    Controls Rear:

    AC power switch, Ch. 1 and Ch. 2 gain control
    10-pole DIP switch featuring LF filter on/off, LF filter 30/50 Hz, Clip Limiter on/off controls for each channel and switches for selecting Stereo, Parallel, or Bridge mode. Push-button circuit breaker for each channel.
    Voltage Gain 64x (36 dB) for 8 ohm load
    Input Impedance 20 k ohm balanced, 10 k ohm unbalanced
    Indicators

    Power-On: Green LED, Protect: Red LED
    Signal -30dB: Yellow LED, Clip: Red LED
    Connectors Input:
    Connectors Output:
    XLR female, TRS (1/4-inch), and barrier-strip screw terminals, each channel
    Binding posts and Speakon outputs (Ch. 1 Speakon wired for biamp)
    Cooling Continuously variable-speed fan, rear-to-front air flow
    Amplifier Protection

    Short circuit, open circuit, thermal, ultrasonic, and RF protection. Stable into reactive or mismatched loads
    Load Protection On/off muting, DC fault output crowbar
    Power Requirements 100, 120 or 240 Volts AC (±10%) 50-60 Hz (factory configured)120V models require 20 Amp, 120V service and are supplied with a NEMA 5-20 plug on the cordset.
    Dimensions 19" 19.0" (48.3 cm) wide, 5.25" (13.3 cm) tall, 15.9" (40.39 cm) overall depth
    Weight 75 lb (34.02 kg) net, 87 lb (39.46 kg) shipping





    RMX-5050List price: $2,627.00Your price: $1,699.99



  • Cables - Connectors | Computer DJ - Audio | Amplifiers | Cartridges | Cases - Racks - Stands | CD / MP3 Players | Lighting - Club - DJ - Pro | Video Walls | Truss | Headphones | Microphones | Mixers - Consoles | Processors - Rack Gear | Speakers - Monitors | Systems - Packages | Turntables | Karaoke Gear | Musical Instruments | PA Systems | Production Gear | Studio Recording Gear | Outlet - Open Box | Retired Products | Photo Archives | Info - Terms | Testimonials | Privacy Policy | Contact Us | Tour Six Star DJ |Links | Site Index | Home



    Copyright © 1996-2017 SixStarDJ.com - All rights reserved

    Providing quality service since 1996, sixstardj.com is your top supplier of dj equipment, professional audio, lighting products, computer audio & musical instrument products from the top brands in the music industry. [[ ALL PRODUCTS SUBJECT TO AVAILABLE STOCK - SOME ITEMS MAY NOT BE AVAILABLE FOR IN-STORE PICKUP. ]]